![]() These steps adjust the positioning for only a single table, so you'll need to repeat the steps for the other two tables, as well. Click OK to close the Table Properties dialog box.In the Text Wrapping section choose None.Click OK to close the Table Positioning dialog box.Set the Vertical Position to 0 Relative to Paragraph.Make sure the Move with Text check box is selected.(This button is only available after you perform step 3.) Word displays the Table Positioning dialog box. In the Text Wrapping section choose Around.The Table tab of the Table Properties dialog box. Word displays the Table Properties dialog box. Right-click in the first table and select Table Properties from the Context menu.Assuming that the tables are to be displayed underneath one another the steps are: The solution is to set paragraph anchors and no text wrapping for all tables and then make sure that the table anchors are successive paragraphs. Thus, you can easily see overlap of the tables and other strange behavior. Therefore, paragraph anchors are at different positions on the page whereas the page-anchored table is in a fixed position. The other person's copy of Word has different settings from yours for font sizes and line spacing. However, when you send the document to a different person, then all heck breaks loose. The tables have probably, at some stage, been dragged up or down and perhaps blank lines have been added to position them on the page. It sounds as if one of Donna's tables is anchored to the page (or margin) and another is anchored to a paragraph. If you subsequently drag a table up or down using the mouse, then the anchor changes to the nearest paragraph mark plus an offset and the wrapping changes from the default of "none" to "wrap around." Often this change of wrap radically changes the layout of the page and you have to change the table back to "no wrap" to resolve the chaos. ![]() If successive tables are anchored to successive paragraph marks, then the tables will all move together and cannot overlap. The table will then move up and down as that particular paragraph mark moves with editing. Welcome to the wonderful world of table positioning in Word! When you insert a table using the ribbon tools, the vertical anchor is set to "paragraph," by default. She wonders how to prevent this from happening. When she sends it to someone else the tables move and overlap each other. When she views it, the document appears fine. Donna has a document that has three tables in it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |